Auger 12SBG-V22 68cc auger Garland AUGER
- Displacement: 68 cc
- Cutting diameter: 20 cm
- Bit length: 80 cm
- Weight: 15.7 kg
€356.72 VAT incl.
The Garland SMASH AUG50-V20 is powered by a 2-stroke gasoline engine. It provides a total power of 1550 W and a total displacement of 49.8 cc. This model has a tank capacity of 1.25 cm3.
The SMASH AUG50-V20 model from Garland offers a cutting length of 15 cm in diameter. It also offers an 80 cm length of the gullet.
The Garland SMASH AUG50-V20 model has a total packaged product weight of 15.5 kg. In addition, it has a packaged product dimensions of 123cm in height, 41cm in width and 32cm in depth.
Commercial reference | SMASH AUG50-V20 |
Tank capacity (in l) | 1,25 |
Displacement (in cm³) | 49,8 |
Fuel consumption at maximum power (kg/h) | |
Cutting diameter (cm) | 15 |
Warranty (in years) | 2 |
Language of instructions | English, Spanish, Italian, French, French, Portuguese, Greek, Spanish |
Cutting length (in cm) | Diameter 15 cm |
Bit length (cm) | 80 |
Guaranteed sound power level Lw(dB(A)) | 114 |
Sound pressure level (dB(A)) | 96 |
Weight (kg) | 7 |
Packaged product: height (in cm) | 123 |
Power (in W) | 1550 |
Packaged product: weight (in kg) | 15,5 |
Engine speed at idle (min-1) | 3.000 |
Maximum engine speed at idle (min-1) | 9.000 |
Engine type | 2-stroke |
Never transport the machine while the engine is running. Also switch off the engine whenever moving between different work areas.
Wait 5 minutes after switching off the engine before transporting the machine.
If transporting the machine in a vehicle, secure the machine firmly to prevent it from sliding or tipping over and secure it with the guard on the cutting elements.
Wait 5 minutes after switching off the machine for the machine to cool down before storing or transporting the machine. The exhaust pipe of the machine will still be hot after the engine is turned off. Never store the machine near flammable materials (dry grass, wood, etc.), gas or combustibles.
Store this tool in a place that is not accessible to children and safe so as not to endanger any person and that is dry, clean and at a temperature between 0°C and 45°C
Before storing the machine follow the points in the maintenance chapter.
Always store the machine with the cutting element guard installed.
If you are going to store the machine in a closed place empty the fuel as the vapors could come into contact with a flame or hot body and ignite. If the fuel tank has to be
if the fuel tank has to be emptied this should be done in the open air and following the recycling regulations.
To reduce the risk of fire, keep the engine, muffler and fuel tank clean by removing cut material, oil and grease.
IMPORTANT NOTICE |
It is mandatory for the customer to check oil and grease levels before start-up. If it is not possible to check the goods at the moment of reception, it must be indicated on the carrier's sheet that the customer is in agreement except for pending examination. |
Data sheet
Specific References